AC Evaporator Repair | GT Pit Stop Automotive Services in Riverside

GT PIT STOP AUTOMOTIVE SERVICES > The Best Auto Repair And Maintenance Services > AC REPAIR > REPAIR YOUR CAR'S AC EVAPORATOR

Moisture is the enemy of your car's air conditioning system. The evaporator is your AC system's front line of defense against unwanted moisture. Replacing a car AC evaporator is not an easy job and should only be attempted by the pro mechanics at GT Pit Stop Automotive Services in Riverside.

Replacing the entire evaporator assembly will save time and money down the road. Accessing your car's AC evaporator is easy because it is mounted inside the cabin of your vehicle. In fact, you can access your evaporator through your car's glove box. However, the lines going to and from the evaporator run throughout your air conditioning system and replacing them requires the disassembly of the engine bay.

Trust GT Pit Stop Automotive Services in Riverside To Replace Your Car's Evaporator

Get AC unit full seal testing
Identify and repair internal corrosion issues.
Find troublesome micro cracks and leaks in the evaporator core
Pressurize and calibrate the AC system to manufacture standards

More AC Repair Services:

AC Repair Services

AC Freon Recharging

AC thermal expansion valve or orifice tube replacement

hours

Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday

7:00AM - 5:00PM
7:00AM - 5:00PM
7:00AM - 5:00PM
7:00AM - 5:00PM
7:00AM - 5:00PM
8:00AM - 3:00PM
Closed
Contact us

GT Pit Stop Automotive Services

3222 Motor Circle
Riverside, CA 92504
909-572-6122
Email Us | Get Directions
Vehicle tips
- According to recent studies, 5 percent of all motor vehicle fatalities are clearly caused by automobile maintenance neglect.
- The cooling system should be completely flushed and refilled about every 24 months. The level, condition, and concentration of coolant should be checked. (A 50/50 mix of anti-freeze and water is usually recommended.)
- Never remove the radiator cap until the engine has thoroughly cooled. The tightness and condition of drive belts, clamps and hoses should be checked by a pro.
- Change your oil and oil filter as specified in your manual, or more often (every 3,000 miles) if you make frequent short jaunts, extended trips with lots of luggage or tow a trailer.
- Replace other filters (air, fuel, PCV, etc.) as recommended, or more often in dusty conditions. Get engine drivability problems (hard stops, rough idling, stalling, diminished power, etc.) corrected at a good shop.
- A dirty windshield causes eye fatigue and can pose a safety hazard. Replace worn blades and get plenty of windshield washer solvent.
- Have your tires rotated about every 5,000 miles. Check tire pressures once a month; let the tires cool down first. Don't forget your spare and be sure your jack is in good condition.
- Check your owner's manual to find out what fuel octane rating your car's engine needs then buy it.
- Keep your tires inflated to the proper levels. Under-inflated tires make it harder for your car to move down the road, which means your engine uses more fuel to maintain speed.
- Lighten the load. Heavier vehicles use more fuel, so clean out unnecessary weight in the passenger compartment or trunk before you hit the road.
- Use the A/C sparingly. The air conditioner puts extra load on the engine forcing more fuel to be used.
- Keep your windows closed. Wide-open windows, especially at highway speeds, increase aerodynamic drag and the result is up to a 10% decrease in fuel economy.
- Avoid long idling. If you anticipate being stopped for more than one minute, shut off the car. Contrary to popular belief, restarting the car uses less fuel than letting it idle.
- Stay within posted speed limits. The faster you drive, the more fuel you use. For example, driving at 65 miles per hour (mph) rather than 55 mph, increases fuel consumption by 20 percent.
- Use cruise control. Using cruise control on highway trips can help you maintain a constant speed and, in most cases, reduce your fuel consumption.
- Keep your engine tuned. A fouled spark plug or plugged/restricted fuel injector can reduce fuel efficiency as much as 30 percent.
- Inspect the engine's belts regularly. Look for cracks or missing sections or segments. Worn belts will affect the engine performance.
- Have the fuel filter changed every 10,000 miles to prevent rust, dirt and other impurities from entering the fuel system.
- Change the transmission fluid and filter every 15,000 to 18,000 miles. This will protect the precision-crafted components of the transmission/transaxle.
- Inspect the suspension system regularly. This will extend the life of the vehicle's tires.
Prev Slide Next Slide